Notes for NANOMET Roof Sheet Construction (2)

agricultural metal roofing

Sealing: The cut NANOMET Roof Sheet should be immediately sealed with aluminum foil tape to prevent the powder from leaking out. The unused part of the NANOMET Roof Sheet should be gently laid flat on the spare place. Note: two incisions should be immediately sealed with aluminum foil tape to prevent leakage of powder and damage;

12 ft metal roofing

Opening: For the NANOMET Roof Sheet that needs to pass through the anchoring piece, use a special paper knife to align the middle position of the anchoring piece. Carefully make the incision not too large or deviate from the middle position of the anchoring piece. Carefully cut the incision not too large or deviate from the middle position of the anchoring piece.

slate blue metal roof

Drilling: If it is necessary to drill on site, it is necessary to use two upper and lower plastic plates, cut holes in the plates, clamp the NANOMET Roof Sheet with the plastic plates, and then drill accurately with an electric drill.
Joints: for large gaps in the place, can be filled with cutting material, with aluminum foil tape pasted.
Contact:NANOMET
Tel:0086-(0)757-83128353
mail: service01@nanomet-sales.com